How to routinely maintain the EAS anti-theft alarm gate? [Bohang China]

How to routinely maintain the EAS anti-theft alarm gate? [Bohang China]

Nowadays, in order to better do store anti-theft measures,many shopkeepers have installed EAS anti-theft alarm gate for their stores.This not only reduces the loss rate of goods, but also greatly enhances the enthusiasm of employees,and can save a lot of time to promote sales work.So now you may be facing a problem, how to maintain these EAS anti-theft alarm gate in daily life.

Good maintenance can effectively prevent EAS anti-theft alarm gate damage and easy to find fault problems in time.We can do the following:

1. Firstly you should open the EAS anti-theft alarm gate power before opening the door every day, the indicator light on the power control box is on, it means there is no problem.

2. Next,a self-test on the internal program of the EAS anti-theft alarm gate system. After 30-90 seconds, the self-test ends and the EAS system enters the normal working state.

3. EAS system administrators can test the EAS anti-theft alarm gate with a standard test card or hard tag, the hand keeps the natural droop, so that the standard test card or hard tag plane is level with the EAS anti-theft alarm gate, and then at a distance of 1 meter away from the EAS anti-theft alarm gate. Start to pass the EAS anti-theft alarm gate at normal speed. If the EAS anti-theft alarm gate can trigger an alarm, the alarm sounds, and the light flashes, indicating that the EAS anti-theft alarm gate work is normal.If the system does not have an alarm, you can repeat the above actions several times until it alarms.

4. The EAS anti-theft alarm gate power or main power supply in the store should be turned off after closing the door every day.

All of the above are the basic tasks that we have to do every day to the EAS anti-theft alarm gate. Of course, the appearance of the EAS anti-theft alarm gate is also clean.It is not necessary to spray water or detergent directly. Wipe the wet towel and wipe it gently,otherwise it will easily cause the circuit damage,then causing a short circuit.